dudu-lai This connector contains the CANBUS cable, if the original host does not have this connector, there is no CANBUS cable (and therefore no door information,).
Tarek ok, is it possible to connect the CAN-L & CAN-H wires from the canbus to the ODB port to get this information
maxingato Tarek Where you able to connect this? Do you need to to conect them to the canbus adapter? i want to do same but I will be tapping the CAN lines from the Body Control Unit (BCM)
Tarek Hi, This is the dudu AHD 1080P camera, as you can see the resolution is really bad. is there setting to be configure?
wwest2 Tarek Set the radar as right or left of the rear view in the vehicle setting and see how it looks. I think this is because the video was stretched to be shown in full screen.
Tarek dudu-lai Somehow, the rear view camera image size changed I don't know. how to get the full screen again. before Now
maxingato Tarek Thanks a million. Can you please post a picture of your connections for the reverse camara at the back of the radio please? Did the reverse gear trigger come from the canbus?
DUDU-Meng If your model has a radar display, you can set up a split-screen radar display so that the camera image won't be too wide and distorted.
Tarek DUDU-Meng My card does not has a radar. I just want to get the wide/ full screen like before. So what is the setting I should change?
Tarek DUDU-Meng I just want the widescreen for reversing camera how to get it back? what is the setting that i should change? would you please assist .
