dudu-lai sometimes it was doing like that now im general is not even recognizing whatever i have in the circle on the photo.
Steering wheel learning button problem
Are you sure that buttons are not working via canbus?
If it is you can't learn them.
You just have to set correct canbus in settings.
I connect my cables exactly how it was before but it wasn't working anything. When i try to make the learning procedure the most of the buttons they was working except of volume up/down and next /previous buttons. Doesn't matter how many times i reset my SWC and i make the procedure again and again still that specific buttons they are not working and not even recognize them.
Do they work with oem radio unit? Maybe buttons broke.
Gwinambele Yes they was working perfectly until i remove headunit
Do you have the keys wired through the canbox or to key1?
DUDU-Meng my car doesn't have canbox and i was thinking if that is the issue
xarishewii
That's a wiring issue, there are two steering wheel button learning wires.
You wire it up and you can set the buttons in the settings
That's a wiring issue, there are two steering wheel button learning wires.
You wire it up and you can set the buttons in the setup.
Just connect one of the KEY1/2 wires.
DUDU-Meng But on the car wiring it's 3 cables
One it's ground and another 2 data cables 100% from dudu i connect both key1 and key2 to each of this cables
xarishewii How the cables are connected, please take pictures