xarishewii dudu-lai sometimes it was doing like that now im general is not even recognizing whatever i have in the circle on the photo.
xarishewii DUDU-Meng DUDU-Meng volume up, volume down previous and next buttons. In general whatever i have in the circle is not working. Is not making even studying.
Gwinambele Are you sure that buttons are not working via canbus? If it is you can't learn them. You just have to set correct canbus in settings.
xarishewii I connect my cables exactly how it was before but it wasn't working anything. When i try to make the learning procedure the most of the buttons they was working except of volume up/down and next /previous buttons. Doesn't matter how many times i reset my SWC and i make the procedure again and again still that specific buttons they are not working and not even recognize them.
DUDU-Meng xarishewii That's a wiring issue, there are two steering wheel button learning wires. You wire it up and you can set the buttons in the settings
DUDU-Meng That's a wiring issue, there are two steering wheel button learning wires. You wire it up and you can set the buttons in the setup. Just connect one of the KEY1/2 wires.
xarishewii DUDU-Meng But on the car wiring it's 3 cables One it's ground and another 2 data cables 100% from dudu i connect both key1 and key2 to each of this cables
Sergrek dudu-lai hi, i have a similar problem, there are three wires in the car: 2 for Key1, Key2 and one GND! but on dudu4 there is only Key1 and Key2, where on dudu4 should I connect GND (for Key)? without connecting GND the buttons are not detected!
Mikescotland Sergrek key1 to key1, key2 to ground. Or, some cars might have two matrix banks for buttons, then key1 to key1, key2 to key2 and connect ground to black ground cable in Dudu power connector.
