• HW Installation Support

  • Canbus settings

I have a 2016 Toyota 4 Runner. I purchased the Doodoo auto seven along with high canbus. Currently, my rear back up camera, which is a factory camera does not display. The head unit does detect the vehicle going into reverse and switches the screen however, no image is ever displayed. Also, it appears that the can bust does not feed any data to the head unit that I can tell. I did not find a specific setting for a 2016 Toyota forerunner however I used every possible Can bus option that was even close and none of them appeared to work properly. What cabus settings should I use? And how can I get my Factory rear camera to operate properly? Initially, I tried To take a photo of my about information on the dash, but when I take a photograph that forum says there is an issue with the size of the File size. My system is android version 13. The Cann protocol version currently is selected as unknown. I have run over the air update on the system and it says it is running the latest software. I just purchased the unit directly through Matty on Alibaba right after christmas

    Dylan What kind of CANBUS box are you using? Please take a picture
    Is there a serial port connected to the C connector?

        I will try to get a picture this evening of the back of the unit. I cannot determine which canbus I am using. It is the one that came from mekede along with the dudu7 for a 2016 Toyota 4 runner. When I try to attach a picture here from my iPhone it rejects it as being too large.

        5 days later

        dudu-lai
        It is connected and there is a photo of the canbus as well. Currently I have selected xp simple

        My main issue is that the factory backup camera does not display on the screen

            Dylan You will need to connect the Tulip Lotus connector on the cable to the F connector on the DUDU.

                dudu-lai which tulip connector? There are many.

                    Dylan There is only one F connector, you can try the male connector for each tulip on the cable

                      Does it make a difference or will it interfere with functionality being that this vehicle is a 2016 Toyota forerunner and its reverse camera is 6 V instead of 12 V? And do you mean one of the male tulips from the harness that was sent by duduauto? The vehicle does not have connectors.