• DUDU OS

  • Reverse Camera Error ( Image not displayed under Camera Screen )

To Dear Mods.
I am having issues displaying the reverse camera when the back/reverse gear is initiated. The reverse image can be displayed/viewed under AUX when reverse gear is initiated while" Reversing video screen switch " is turned off. However the reverse camera screen would not show up. If I turn the " Reversing video screen switch" to ON. The image will display for 1 sec under AUX however then will disappear due to the reverse image program is imitated. I know for a fact that the headunit can see the reverse camera as the image is displayed under AUX however I am unable to view the reverse image/video when reverse camera app is initiated.

Video here:

My Vehicle details are as follow:
2021 Toyota RAV4 Hybrid Cruiser
Raise FT - RZ - 02 v52

I have also attached a canbus log for you to review and troubleshoot.

Currently my wiring setup at the back of the head unit is as follows:
20240327_211837.jpeg

  1. 28 pin -
  2. 30 pin - 30_Pin.jpeg
  3. 28 pin - 28_Pin_Black.jpeg

My Vehicle - Factory Set is as below:
Screen 1:
screencap.png

Video is here:
Video

Canbus Log:
Canbus

`

Video is displayed in AUX Mode:
AUX_Video.jpeg
But When Camera App is triggered: No Video is Displayed
No_Video.jpeg

Пожалуйста, сфотографируйте и покажите нам этикетку CAN-бокса и информацию о версии системы.

In the canbus settings I have selected Highlander however even selecting RAV4 2019-2020 it has the same effect as above.

Select this to look at and check the wiring, your video cable is connected to the one in my picture


    DUDU-HUANG
    Thank you Huang.
    I will try to connect that cable to F. Do i need to connect the other cables from connector F like CAM12V and BREAK , IR to the wiring harness ?

        jmorrisson Nothing else is needed, just connect the yellow video plug

          Hi Huang. That worked. Thank you so much. But I have one issue the sensor car image on the left side of the screen covers most of the birdeye view of the camera. Is there a way to make the sensor image smaller so that the background is visible ? The original controls on the camera screen also worked and the Panaromic Bird Eye button on the side of the steering wheel also worked.

            jmorrisson Long press on that car to move the position and zoom in and out with both hands to resize the model