• DUDU OSFunction Request

  • [Feature request] A/C Control Panel and Hard coded Canbus SWC

Hi, i have some suggestions for new features.

Feature request:

  • For new A/C Control Panel (in Pop-up mode), resize vent control for a bigger one (or add a setting to choose small and large).
  • For new A/C Control Panel (in Full Screen), add a auto-close timer (like pop-up mode).
  • Ability to modify hard coded canbus steering wheel control.
    Example: for my Peugeot 308 T9 (2014), i want to set the "Turn off screen" button to "Show A/C Control Panel"
  • Ability to choose between the new and old A/C control panel with a switch, "use new A/C Control Panel (for compatible vehicle)" in dev settings, for exemple.

For pop-up delay, is it possible to start timer delay after the last press ?
Actually, delay start when i open the pop-up, and whatever i do, it close automatically after 5 seconds (if the timer is set to 5 seconds).

  • Add Peugeot 308 T9 2014 (Raise Canbus, RZ-PSA-15) to compatible list for new A/C interface (On my 308 T9, if i choose a compatible interface in canbus selection (like Peugeot 3008), i can control A/C with new panel and access to the new vehicle information panel.

And some questions:

  • Is it possible to change bluetooth name "DUDUAUTO" by custom bluetooth name ?
  • For Radio app: is it possible to clean image from radio station ?

Thanks

    Geruda32 I will try that for my Peugeot RCZ also.

      Geruda32 Does the the A/C control screen work for you when seleced 3008? Which of the 4 selections (high/mid/low/keep) dos you use?
      For me the steering whel controls work but nothing happens when I pross buttons on the A/C screen, no values are displayed and if I change settings on the physical knobs it has no effect for me on the A/C screen.

      Do you see a firmware version for your CANBUS decoder?

          dudu1897
          Hi,
          Yes, A/C control panel work with RZC/Peugeot-Citroën/3008/Mid or Low configuration, everything work except call button.
          Canbus version show "Unknown", my canbus box: RZ-PSA15 (24.04.17), SW: 0125
          This configuration work on my Peugeot 308 T9 2014, but if your Peugeot RCZ has knob to configure A/C Temp, i don't know if it can work in this configuration.
          Ask Dudu-Meng for more details.

              Geruda32 Thank you. I thougt the configuration could be the same because RCZ is using components from 308 and 3008 but it seams not to be for the A/C control.

                Another feature request: Add external temp (read by canbus) in navbar (in front of time).

                14 days later

                You can have it on the right upper corner.

                  dudu1897
                  Hi,
                  Yes, but if i open navigation app (for exemple) in fullscreen mode, this data disappears.
                  And if i want to know outside temp, i have to go back to the launcher each time (or enable android status bar).
                  Implementing this (disableable) data in the navbar would be useful in every way.