Ford Mustang V6 Base 2013 CANBUS

dudu-lai

lHopital DUDU does not support TPMS display for such OBD devices

lHopital

I only used the OBD device to check if the TPMS values are available in the MS-CAN where the canbus box is connected.

dudu-lai

Record the CANBUS log of the camera track with your camera, upload it to Google Drive and share it with us!

lHopital

dudu-lai
The canbus box does not provide steering wheel angle information, because it is not available on the MS-CAN where the canbus box is connected.

Steering wheel angle is available from two modules on the HS-CAN bus. This information can be read with any OBD2 device. Also with the bluetooth one that is connected to DUDU for speed, fuel level etc.

The question is, does DUDU OS somehow support steering wheel angle over OBD?

lHopital

dudu-lai
https://drive.google.com/file/d/1_SrZ6nj6tTqCnjNX60_lxFOa_PLyNS-z/view?usp=sharing

I took this video with the car running and steering wheel turning the whole time.
As far as I can see, there is no information for steering wheel angle.

dudu-lai

lHopital DUDU cannot get track information in OBD2 devices
It can only get the track information of the CANBUS box, if the CANBUS box does not have the steering wheel corner information, you can replace the CANBUS box of other brands to try.

dudu-lai

dudu-lai Is the video recorded without being in reverse gear? Some CANBUS bus boxes need to have a reverse gear signal in order to send steering wheel corner information to the android radio

lHopital

dudu-lai
Good point, it was not in reverse. I will try again in the evening.

I tried looking for other brands like Raise or so, but I can't find other.. The controls below the dudu are connected to the canbus box. Therefore, it seems I have to use this one.

lHopital

dudu-lai
When I'm in reverse gear, there is almost no output from canbus. Nothing when turning the steering wheel.
Would have been a nice to have feature, but not important.

For the TPMS information, I just install Touque Pro App and show it like that. That is good enough for me.

Thank you for your quick support.

The only thing that is a bit annoying at the moment, is the climate control display and the Touch assistant app. If you could consider to improve it in the future, that would be really nice.
In case you need more information from me for that, let me know.

Isk

Were you able to track down a canbus box that reads HI-CAN and MS-CAN with output to the DUDU7?

lHopital

Isk
Only with OBD2, but not canbus directly.
It is really difficult to find a lot of different canbus boxes. With a lot of work it would be possible to build an own one, but I don't time for that.

At the moment I just hope that the new climate control will be implemented for my car, but I'm not sure this will happen...

Isk

Would having MS-CAN readable with a BT ODBII reader help?

https://www.obdlink.com/products/obdlink-mxp/?ref=forscan